Cisco MGX 8850 Command Reference Manual page 193

Chapter 3 Equipment and Resource Provisioning
-emax
-imin
-imax
-vpmin
-imax
-vcmin
-vcmax
-mincon
-maxcon
Related Commands
addpart, delpart, dsppart, dsppart
Attributes
Log: log
Example
For logical port 1 on partition number 2, configure the PNNI controller (the number 2) to have 10%–15%
of the bandwidth on both the ingress and egress, a VPI range of 20–100, a VCI range of 1–32767, a
minimum guaranteed number of 1000 connections (or channels) and a maximum of 2000 connections.
MGX-01.1.2.PXM.a > cnfpart 1 2 2 100000 150000 10000 15000 20 100 1 32767 1000 2000
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specifies the maximum percentage of the bandwidth. Each unit of egrMaxBw is
0.00001 of the total bandwidth available to the port. (An egrMaxBw of 1000000 =
100%.) The resulting bandwidth must be at least 50 cps.
Specifies the guaranteed percentage of the ingress bandwidth. Each unit of ingMinBw
is 0.00001 of the total bandwidth available to the port. For example, an ingMinBw of
1000000 = 100%.
Specifies the maximum percentage of the ingress bandwidth. Each increment of
ingMaxBw is 0.00001 of the total bandwidth on the port. For example, an ingMaxBw
of 1000000 = 100%. Note that the maximum ingress bandwidth must be at least 50
cps.
Specifies the minimum VPI. For NNI, the range is 0–4095. For UNI, the range is
0–255.
Specifies the maximum VPI in the range 0–4095 for an NNI. For a UNI, the range is
0–255. The maxvpi cannot be less than the minvpi.
Specifies the minimum VCI in the range 0–2000 (OC-48 only) or 32–65535.
Specifies the maximum VCI in the range 0–2000 (OC-48 only) or 32–65535.
Specifies the guaranteed number of connections. The range is between 0 and the
maximum number of connections in the port group. See dspcd for information about
port groups.
Specifies the maximum number of connections. The range is between 10 and the
maximum number of connections in the port group. See dspcd port group
information. maxConns cannot be less than minConns.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnfpart
3-33