Cisco MGX 8850 Command Reference Manual page 433

Chapter 6 Logical Node, Port, and Signaling Commands
-trace
-timeout
-data
-interval
Related Commands
dsppingatmaddr
Attributes
Log: log
Examples
Ping the ATM end station with the address 47.00918100000000500ffde873.00500ffde873.0.
svcpop1.1.PXM.a > aesa_ping 47.00918100000000500ffde873.00500ffde873.01
Ping Got CLI message, index=0
PING:from PNNI - SOURCE ROUTE
DTL
DTL 1:NODE 1::56:160:71:0:145::238:238:238:238:
Port 1:263168
DTL 1:NODE 2::56:160:71:0:145::15:253:232:115:
Port 2:0
Port List :no of ports =
Port ID
svcpop1.1.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Enable path trace during ping. This parameter only applies if -setupcall is enabled.
Possible values: yes or no
Default: no
Connection timeout for the ping. This parameter applies only if setupcall is enabled.
Range: 5–120 seconds
Default: 5 seconds
If you enable data, the switch transfers data then prints statistics at the end of the
timeout.
Possible values: enable or disable
Default: disable
The interval between the call setup of successive transmissions. This parameter
applies only if setupcall is enabled.
Range: 5–120 seconds
Default: 5 seconds
State: active
1 :Number of (Node/port)elements
1
1:263168
Privilege: SUPER_GP
2
Cisco MGX 8850 Routing Switch Command Reference
aesa_ping
6-15