Dspport - Cisco MGX 8850 Command Reference Manual

dspport

dspport
Display Port
Displays the configuration for a logical port. The displayed information is shown in the example. For a
description of each item, see addport.
The total number of connections in the display includes control VCs. The types of control VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts that do not include
control VCs, use dsppnport.
The SCT ID that dspport shows pertains to the port. For the card-level SCT ID, use dspcd.
Note
Cards on Which This Command Runs
AXSM
Syntax
dspport <ifNum>
Syntax Description
ifNum
Related Commands
addport, dnport, dspports
Attributes
Log: no log
Cisco MGX 8850 Routing Switch Command Reference
3-84
A logical port (interface) number. Only one logical port is allowed if the line operates
as a UNI or NNI. For the virtual network to network interface (VNNI), multiple ports
can exist on a line. For AXSM, the range 1–60.
State: active, standby
Chapter 3 Equipment and Resource Provisioning
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001