Dsplns - Cisco MGX 8850 Command Reference Manual

Chapter 9 Troubleshooting Commands

dsplns

Display Lines
Displays the configuration for all lines on a card. For each line, the output information consists of the:
•
•
•
•
•
•
•
•
•
•
•
For information on an individual line, use dspln. Also, the dspln command shows the transmit clock
configuration if one exists.
Cards on Which This Command Runs
AXSM
Syntax
dsplns
Related Commands
cnfln, delln, dspcds, dspln, upln
Attributes
Log: no log
Example
Display the configuration of the lines on an AXSM-4-622.
pop20two.1.AXSM.a > dsplns
Sonet
Line
----- ----- ------------ ------ -------- ------ ------- ------
1.1
1.2
2.1
2.2
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Bay and line number
Line state—up (active) or down (inactive)
The line type
Whether any loopback currently exists on the line
Line coding
Frame scrambling status (enabled or disabled)
Configured line length in meters (applies to only T3 or E3)
Criteria for Out of Frame (OOF) error (applies to only T3 or E3)
Whether C-bit (AIS) checking is enabled (applies to only T3 or E3)
The medium line type—long reach, single-mode fiber, for example
The alarm status—clear, critical, and so on
State: active, standby
Line Line
State Type
Down sonetSts12c NoLoop
Down sonetSts12c NoLoop
Up sonetSts12c NoLoop
Up sonetSts12c NoLoop
Privilege: ANYUSER
Medium Medium
Line Frame Line
Lpbk Scramble Coding Type
Enable Other
Enable Other
Enable Other ShortSMF Clear
Enable Other ShortSMF Critical
Cisco MGX 8850 Routing Switch Command Reference
Line Alarm
State
Other Clear
Other Clear
dsplns
9-115