Cisco MGX 8850 Command Reference Manual page 550

Chapter 7 SPVC and SVC Commands
addcon
In the following two examples, the connection works with default values of PCR, SCT, MCR taken from
the SCT. Defaults applied for the connection can be viewed by using the dspcon command.
MGX8850.1.11.AXSM.a > addcon 1 10 40 1 s
slave endpoint added successfully
slave endpoint id : 00000E1000001C008051B730FFFFFF010B180100.10.40
MGX8850.1.11.AXSM.a > addcon 1 10 50 1 m -slave
00000E1000001C008051B730FFFFFF010B180100.10.40
master endpoint added successfully
master endpoint id : 00000E1000001C008051B730FFFFFF010B180100.10.50
In the following two examples, the connection works with default values of SCR, MCR derived from the
PCR value specified using lpcr and rpcr keywords. Defaults applied for the connection can be viewed
by using the dspchan command.
MGX8850.1.11.AXSM.a > addcon 1 10 40 1 s
slave endpoint added successfully
slave endpoint id : 00000E1000001C008051B730FFFFFF010B180100.10.40
MGX8850.1.11.AXSM.a > addcon 1 10 50 1 m -slave
00000E1000001C008051B730FFFFFF010B180100.10.40 -lpcr 1000 -rpcr 1000
master endpoint added successfully
master endpoint id : 00000E1000001C008051B730FFFFFF010B180100.10.50
Cisco MGX 8850 Routing Switch Command Reference
7-14
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001