Dsppnilmi - Cisco MGX 8850 Command Reference Manual

Chapter 4 ILMI Commands

dsppnilmi

Display PNNI ILMI
Displays the ILMI information for a PNNI logical port. The ILMI state can be one of the following.
Disable
NotApplicable
LostConnectivity Protocol on listening port is not enabled.
EnableNotUp
UpAndNormal
Note The VC for ILMI is a control channel, but its bandwidth parameters are fixed, as follows:
PCR=1000 cps; SCR=50cps; and MBS=1024 cells.
The bandwidth used by ILMI (when enabled) and other control-type VCs (see cnfpnctlvc) adds to
the bandwidth load on the port. Use dspload to determine the load on port resources.
Cards on Which This Command Runs
PXM45
Syntax
dsppnilmi <portid>
Syntax Description
portid
Related Commands
dspilmi
Attributes
Log: nolog
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Protocol is not enabled on this port.
This port is not accessible due to hardware-related conditions.
This port is not accessible due to hardware.
This port is physically up, and the protocol is enabled.
The portid is the PNNI physical port. The format is
[shelf.]slot[:subslot].port[:subport]. See also
State: active, standby
PNNI Format, page
Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppnilmi
4-2.
4-21