Cnfclkparms - Cisco MGX 8850 Command Reference Manual

Chapter 2 Shelf Management Commands

cnfclkparms

Configure Clock Parameters—configure line characteristics for an E1 BITS clock
The cnfclkparms command lets you configure the signal type and cable type for E1 BITS sources. The
configuration applies to both (upper and lower) sources.
Note In the current release, you can specify only the cable type.
Cards on Which This Command Runs
PXM45
Syntax
cnfclkparms <signal type> <cable type>
Syntax Description
signal type
cable type
Related Commands
None
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specifies whether the signal type for the clock is data or a synchronization
signal. Enter a 1 for data or a 2 for synchronization.
Specifies whether the cable is a twisted pair or a coaxial cable. Enter a 1
for twisted pair or 2 for coaxial. The default is 1.
State: active Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
cnfclkparms
2-19