Cisco MGX 8850 Command Reference Manual page 335

Chapter 5 PNNI Commands
cnfpnni-svcc-rcc-timer
Configure PNNI Switched Virtual Connection Routing Control Channel (SVCC-RCC) Timer—specify the parameters
for any PNNI RCCs between logical nodes.
The current release does not support this command. The cnfpnni-svcc-rcc-timer command lets you
specify the initial PNNI SVCC-based variables for a network node. Logical group nodes (LGNs) use
SVCC-RCCs to exchange routing information.
Cards on Which This Command Runs
PXM45
Syntax
cnfpnni-svcc-rcc-timer <node-index>
[-initTime init-time]
[-retryTime retry-time]
[-callingIntegrityTime calling-integrity-time]
[-calledIntegrityTime called-integrity-time]
Syntax Description
node-index
-initTime
-retryTime
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
In the current release, the only supported value for node-index 1. The node
index indicates the relative level of the logical node within a multi-peer
group on the switch. The range is 1–10, and the lowest level is 1.
Range: 1–10
Default = 1
The number of seconds this node waits before it advertises its choice of
preferred SVCC to a neighbor with a numerically lower ATM address. This
node does so after determining that such an SVCC should be established.
Range: 1–10 seconds
Default = 10
The number of seconds this node waits before it attempts to re-establish an
apparently necessary and viable SVCC-based RCC that was unexpectedly
torn down.
Range: 10–60 seconds
Default = 60
Cisco MGX 8850 Routing Switch Command Reference
cnfpnni-svcc-rcc-timer
5-41