Dnpnport - Cisco MGX 8850 Command Reference Manual

dnpnport

dnpnport
Down PNNI Port
The dnpnport command takes a UNI or NNI port out of service (administratively "downs" a port). For
example, downing a port is necessary for certain provisioning activity or maintenance activity. Where
appropriate, the applicable commands state that you must down a port by using dnpnport.
This command deletes all connections on a port—except for SPVCs whose endpoints are on the port.
Note
Cards on Which This Command Runs
PXM45
Syntax
dnpnport
Syntax Description
portid
Related Commands
addpnport, delpnport, uppnport, dsppnport
Attributes
Log: log
Examples
Remove port 11:2.8:22 from service.
Geneva.7.PXM.a > dnpnport 11:2.8:28
Geneva.7.PXM.a >
Cisco MGX 8850 Routing Switch Command Reference
6-64
< >
portid
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport]. See
also PNNI Format, page 6-4.
State: active
Chapter 6
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Logical Node, Port, and Signaling Commands