Cnfcdvtdft - Cisco MGX 8850 Command Reference Manual

cnfcdvtdft

cnfcdvtdft
Configure Cell Delay Variation Tolerance Default
For all connections of a particular service type on a PNNI logical port, cnfcdvtdft configures the default
number of microseconds for the cell delay variation tolerance (CDVT). The direction is ingress. The new
configuration applies to new incoming calls but not existing calls. You can execute cnfcdvtdft whether
the port is in the provisioning state (prior to addport on the service module) or administratively up.
Cards on Which This Command Runs
PXM45
Syntax
cnfcdvtdft <portid> <service_category>
[microseconds]
Syntax Description
portid
<service_category>
micro seconds
Related Commands
dspcdvtdft
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
7-22
The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also
Service type: cbr, rtvbr, nrtvbr, ubr, or abr.
The number of microseconds for CDVT.
Range: 0–2147483647
Default = 250,000
State: active Privilege: GROUP1
Chapter 7 SPVC and SVC Commands
PNNI Format, page
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
7-4.