Identifying Physical And Logical Elements; Axsm Format - Cisco MGX 8850 Command Reference Manual

Routing switch

Hide thumbs Also See for Cisco MGX 8850:

Table of Contents

SPVC and SVC Commands

AXSM-16-T3E3

Identifying Physical and Logical Elements

The Private Network-to-Network Interface (PNNI) control protocol and the service modules use

different formats to identify the same entity. For example, the format of a logical port that you enter on

an AXSM is different from the format you would enter on the PXM45. This section describes these

formats in the PNNI and AXSM contexts and how they correspond to each other. The parallel actions of

configuring or displaying logical elements on different cards is broadly illustrated in the Cisco

MGX 8850 Routing Switch Software Configuration Guide, Release 2.0.

Apart from the way PNNI and the lower levels of logic identify the same element, the sequence of

commands also needs explanation. When you configure logical ports—for just one example—you must

complete certain tasks on the AXSM CLI before or after related PNNI tasks. For certain commands, this

manual lists prerequisite commands or tasks. For more details on the sequence of tasks, refer to the Cisco

MGX 8850 Routing Switch Software Configuration Guide, Release 2.0, for more details of this sequence.

On a service module, you identify the follow when you provision the capabilities of the card:

Release 2.0, Part Number 78-10467-04 Rev C0, October 2001

Maximum Connections by Connection Type and Front Card

Maximum Connections on Back Cards and Lines

Back Card Maximum

Logical port

Resource partition

Physical Line Maximum

Cisco MGX 8850 Routing Switch Command Reference

Identifying Physical and Logical Elements

Table of Contents