Cisco MGX 8850 Command Reference Manual page 69

Chapter 2 Shelf Management Commands
Related Commands
cnfuser, dspusers, deluser, cnfpasswd, whoami
Attributes
Log: log
Example
Add a user named "fin" with privilege level GROUP1. To add a GROUP1 user, the current user-prefilter
level must be SUPER_GP or higher. To determine the current username, execute the whoami command.
To see all current privilege levels, execute dspusers.
If the privilege level of the current user in this example is GROUP1 or lower, the command fails after
you enter the password for the second time, and the system returns a message stating that you entered
an incoherent value for "–l " (the level).
pinnacle.7.PXM.a > adduser fin GROUP1
Enter password:
Re-enter password:
Add the user "leroy" but without establishing a password for "leroy." The system displays the default
password "newuser." Subsequently, either a network administrator or the user "leroy" can execute the
cnfpasswd command to create a password.
pop20two.7.PXM.a > adduser leroy ANYUSER
Enter password:
(default password "newuser" will be used)
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
adduser
2-11