Dbgpnni - Cisco MGX 8850 Command Reference Manual

dbgpnni

-nbr
-election
-nodereachability
-itf
-address
-lgn
-itdb
-cp
Cisco MGX 8850 Routing Switch Command Reference
5-48
Specify whether the PNNI neighbor FSM debug messages go to the console.
on: The PNNI neighbor FSM messages go to the console.
off: The PNNI neighbor FSM debug messages do not go to the console.
Default: none
Specify whether the PNNI PGL election debug messages go to the console.
on: The PNNI PGL election messages go to the console.
off: The PNNI PGL election debug messages do not go to the console.
Default: none
Specify whether the debug messages about PNNI node reachability computation
go to the console.
on: The PNNI node reachability computation messages go to the console.
off: The PNNI node reachability computation is not active.
Default: none
Specify whether the interface FSM debug messages go to the console.
on: The interface FSM messages go to the console.
off: The interface FSM debug messages do not go to the console.
Default: none
Specify whether the debug messages for address handling go to the console.
on: The debug handling on addresses is active.
off: The debug handling on addresses is not active.
Default: none
Specify whether the PNNI logical group node debug messages go to the console.
on: The PNNI logical group node messages go to the console.
off: The PNNI logical group node debug messages do not go to the console.
Default: none
Specify whether the debug messages about the internal topology database (IDB)
go to the console.
on: The debug messages about the IDB go to the console.
off: The debug messages about the IDB do not go to the console.
Default: none
Specify whether the control point debug messages go to the console.
on: The control point debug messages go to the console.
off: The control point debug messages do not go to the console.
Default: none
Chapter 5
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
PNNI Commands