Dnln - Cisco MGX 8850 Command Reference Manual

Chapter 9 Troubleshooting Commands

dnln

Down Line
Use dnln to de-activate a line on the current card. Before you can de-activate a line, you must:
Remove connections. Use delcon or delcons.
Step 1
Step 2 Remove any resource partitions. Use dsprscprtn to see existing partitions and delrscprtn to remove
partitions.
Step 3 Remove all logical ports. Use dspports to see existing logical ports on the line and delport to remove
logical ports.
Cards on Which This Command Runs
AXSM
Syntax
dnln <bay.line>
Syntax Description
bay.line
Related Commands
dspln, dsplns, cnfln, upln
Attributes
Log: log
Example
De-activate line 1 in bay 1.
MGX8850.1.AXSM.a > dnln 1.1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specifies a SONET line (OC-3c, OC-12c, OC-48c) or a DS3 line (E3 or T3), the bay
(1 for upper or 2 for lower), and the line number. The line number ranges from 1 to
the highest number line on the back card.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
dnln
9-49