Cisco MGX 8850 Command Reference Manual page 151

Chapter 2 Shelf Management Commands
Example
Specify version 2.0(2) for the card in slot 9. In addition to setrev, this example shows other commands
you could use before and after setrev. The sequence begins with a display of all the cards. While the
firmware is going into the RAM on the card, periodically execute dspcds on the PXM45 to see the
changing status of the target card. After setrev finishes, execute dspcd on the targeted service module
to see the version and other details of the card or dspversion to see just the version.
Step 1 On the PXM45, use dspcds. The display shows slot 9 has a card with no firmware.
pinnacle.7.PXM.a > dspcds
pxm45tl
Boot F/W Rev: 0.0(0)
Backplane Serial No: _UNKNOWN___ Backplane HW Rev: 00.00
Statistics Master IP Address: 0.0.0.0
Card
Slot
---
01
02
03
04
05
06
07
08
09
10
11
12
13
14
Step 2 Change directories to the "FW" (firmware) directory.
pinnacle.7.PXM.a > cd /FW
Step 3 List the contents of the directory:
pinnacle.7.PXM.a > ls
The display shows the names of the firmware files. Extract the AXSM version number—2.0(2):
pxm45_002.000.001-D.fw
pxm45_002.000.014-A1_bt.fw
axsm_002.000.002.fw
Type setrev and specify version 2.0(2) as the primary firmware version for slot 9.
Step 4
pinnacle.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Front/Back Card
Card State Type
---------- --------
Empty ---
Empty ---
Empty ---
Empty ---
Empty ---
Empty ---
Active/Empty UNKNOWN_FC
Empty Resvd/Emp UNKNOWN_FC
Failed/Empty UNKNOWN_FC
Empty ---
Empty ---
Empty ---
Empty ---
Empty ---
setrev
9 2.0(2)
System Rev: 00.00 Jan. 05, 2000 15:18:40 GMT
H/W Rev: 00.00 GMT Offset 0
Alarm Redundant
Status Slot
-------- -------
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
NONE 08
MAJOR 07
NONE NA
--- ---
--- ---
--- ---
--- ---
--- ---
Cisco MGX 8850 Routing Switch Command Reference
Shelf Alarm: NONE
Redundancy
Type
-----
---
---
---
---
---
---
PRIMARY SLOT
SECONDARY SLOT
NO REDUNDANCY
---
---
---
---
---
setrev
2-93