Dncon - Cisco MGX 8850 Command Reference Manual

dncon

dncon
Down Connection
Temporarily deactivates (or downs) a connection so you can modify or troubleshoot it. The dncon
command applies to only an SPVC. Execute at the master endpoint of a connection. Subsequently, when
you view commands with dspconinfo or dspcon at the master endpoint, the display shows the
connection state as down. If you execute either of these commands at the slave endpoint, the state
appears as failed.
To reactivate the connection, use upcon.
Cards on Which This Command Runs
AXSM
Syntax
dncon <ifNum> <vpi> <vci>
Syntax Description
ifNum
vpi
vci
Related Commands
upcon
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
9-48
The logical port number. The range for AXSM is 1–60.
Virtual path identifier in the range 1–255 for a UNI or 1–4095 for an NNI.
For a virtual connection (VCC), the VCI range is 0–65535. For a virtual path
connection (VPC), the VCI is always 0.
State: active
Chapter 9
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands