Dspcd - Cisco MGX 8850 Command Reference Manual

dspcd

dspcd
Display Card
Display the following information about a card:
•
•
•
•
Note The connection count includes control VCs when you execute dspcd on the CLI of a service module.
However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the display
does not include control VCs.
•
Some of the information that dspcd shows can also be displayed using the version command, but
version shows the boot code version in bold.
The total number of connections in the display includes control VCs. The types of control VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts that do not include
control VCs, use dsppnport.
Cards on Which This Command Runs
PXM45, AXSM
Syntax
dspcd
Syntax Description
This command does not take parameters.
Related Commands
dspcds, version
Cisco MGX 8850 Routing Switch Command Reference
3-54
Hardware serial number.
Firmware revision level. (See the loadrev description for an explanation of how to interpret the
revision field.)
Status, possibly including the reason for the last reset (FunctionModuleResetReason) and state of
the integrated alarm (cardIntegratedAlarm).
For a service module only: a count of configured lines, ports, and connections.
For a service module only: which physical lines constitute a port group and the maximum number
of connections in that port group. A port group consists of one to many physical lines. This
maximum connection count is a function of the hardware interface type (OC-3, OC-12, and so on).
The port group information also shows the number of existing SVCs, SPVCs, and SPVPs.
Use the maximum number of supported connections to help you configure resource partitions. If a
particular resource partition has close to the maximum supported by hardware on a line, few or no
connections would be possible in another partition on the same line.
Chapter 3 Equipment and Resource Provisioning
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001