Cisco MGX 8850 Command Reference Manual page 279

Chapter 4 ILMI Commands
Examples
Enable ILMI on a PNNI port 1:1.1:2. First, disable the port by using dnpnport.
M8850_DC.7.PXM.a > dnpnport 1:1.1:2
M8850_DC.7.PXM.a > cnfilmienable 1:1.1:2 yes
M8850_DC.7.PXM.a > uppnport 1:1.1:2
M8850_DC.7.PXM.a > dsppnilmi 1:1.1:2
Port:
Autoconfig:
Secure Link Protocol:
Change of Attachment Point Procedures:
Modification of Local Attributes Standard Procedure:
Addressreg:
VPI:
Max Prefix:
Max Address:
Resync State:
Peer Port Id:
Peer Addressreg:
Peer Ip Address : 10.10.10.89
Peer Interface Name : atmVirtual.01.1.1.02
ILMI Link State : UpAndNormal
ILMI Version : ilmi30
INFO:
INFO:
M8850_DC.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
1:1.1:2 Port Type:
enable UCSM: disable
enable
Permit All
0 VCI:
16 Total Prefix:
64 Total Address:
0 Node Prefix: yes
16848898 System_Id : 0.192.0.0.0.0
enable
No Prefix registered
No ilmi address registered
PNNI Side:
enable
enable
16
0
0
Cisco MGX 8850 Routing Switch Command Reference
cnfilmienable
symmetric
4-11