Cisco MGX 8850 Command Reference Manual page 391

Chapter 5 PNNI Commands
next higher level binding
information IG length
parent LGN id
parent LGN ATM address
parent PG id
parent peer group PGL
Nodal State IG Parameters
type
length
flags
input port id
output port id
Internal Reachable ATM Address IG Parameters
type
length
flags
port id
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
A 16-bit number.
The current release does not support higher level binding.
The parent LGN ID is a 22-byte hex string. The current release does
not support logical group numbers (LGNs).
The parent LGN ATM address is a 20-byte, hex string. The current
release does not support group numbers (LGNs).
The peer group ID (of length level) assigned to the parent PG. The
peer group is the PNNI local group. The peer group consists of all
PNNI nodes with matching -pgId values. The current release does
not support parent peer groups.
Default: Figure 5-1 shows the factory-set default.
The parent peer group PGL identifier is a 22-byte hexadecimal
string.
The current release does not support PGL.
The ASCII string that indicates the type of the IG nodal state
parameters.
A 16-bit number.
A string of 8-bit flags.
The logical identifier on the input interface. For more details, see
PNNI Format.
Range: 1–2147483648
The logical PNNI identifier on the output interface. For more
details, see PNNI Format.
Range: 1–2147483648
The ASCII string that indicates the type of the internal reachable
ATM address IG parameters.
A 16-bit number.
A string of 8-bit flags.
The logical PNNI identifier on the interface. For more details, see
PNNI Format.
Range: 1–2147483648
Cisco MGX 8850 Routing Switch Command Reference
dsppnni-ptse
5-97