Dspchantests - Cisco MGX 8850 Command Reference Manual

Chapter 9 Troubleshooting Commands

dspchantests

Display Channel Tests—display results of tstdelay or tstconseg commands.
The tstdelay or tstconseg commands test the integrity of the path of a connection in the ingress and
egress directions, respectively. After you successfully start a test through tstdelay or tstconseg, the
returned message directs you to use dspchantests or dspcon to see the results. The same test results
presented by dspchantests appears in the dspcon display, but dspchantests shows only the test results.
Cards on Which This Command Runs
AXSM
Syntax
dspchantests <ifNum> <vpi> <vci>
[-num <count>]
Syntax Description
ifNum
vpi
vci
-num
number
Related Commands
tstdelay, tstconseg, dspcon
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The logical port number. The range for AXSM is 1–60.
The VPI range for the SVC or SPVC is 1–255.
The VCI range for a VCC SPVC is 32–65535. For a VPC, the only VCI value for an
SPVC is 0.
(Optional) A keyword that indicates an aggregate connection count follows.
The number of connections to display.
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dspchantests
9-77