Cisco MGX 8850 Command Reference Manual page 197

Chapter 3 Equipment and Resource Provisioning
-emax
-imin
-imax
-vpmin
-vpmax
-vcmin
-vcmax
-mincon
-maxcon
Related Commands
addrscprtn, delrscprtn, dsprscprtns, dsprscprtn
Attributes
Log: log
Example
For logical port 1 on partition number 2, configure the PNNI controller (the number 2) to have 10%–15%
of the bandwidth on both the ingress and egress, a VPI range of 20–100, a VCI range of 1–32767, a
minimum guaranteed number of 1000 connections (channels) and a maximum of 2000 connections.
MGX8850.1.2.AXSM.a > cnfrscprtn 1 2 2 100000 150000 10000 15000 20 100 1 32767 1000 2000
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
A maximum percentage of the bandwidth. Each unit of egrMaxBw is 0.00001 of the
total bandwidth available to the port. (An egrMaxBw of 1000000 = 100%.) The
resulting bandwidth must be at least 50 cps.
A guaranteed percentage of the ingress bandwidth. Each unit of ingMinBw is 0.00001
of the total bandwidth available to the port. For example, an ingMinBw of 1000000 =
100%.
A maximum percentage of the ingress bandwidth. Each increment of ingMaxBw is
0.00001 of the total bandwidth on the port. For example, an ingMaxBw of 1000000 =
100%. Note that the maximum ingress bandwidth must be at least 50 cps.
Minimum VPI. For NNI, the range is 0–4095. For UNI, the range is 0–255.
Maximum VPI in the range 0–4095 for an NNI. For a UNI, the range is 0–255. The
maxvpi cannot be less than the minvpi.
Minimum VCI in the range 0–2000 (OC-48 only) or 32–65535.
Maximum VCI in the range 0–2000 (OC-48 only) or 32–65535.
A guaranteed number of connections. The range is between 0 and the maximum
number of connections in the port group. See dspcd for information on port groups.
A maximum number of connections. The range is from 10 to the maximum number
of connections in the port group. See dspcd port group information. maxConns cannot
be less than minConns.
State: active Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnfrscprtn
3-37