Cisco MGX 8850 Command Reference Manual page 87

Chapter 2 Shelf Management Commands
Related Commands
dspndparms, dspndalms, dspenvalms
Attributes
Log: no log
Example
Change the time period for counting card resets to 30 minutes. First enter the command with no
parameters. The system displays the options and prompts you to enter an option number (rather than
display the help information for this command). Enter a 2, then the system displays the current value for
this option.
MGX8850.7.PXM.a > cnfndparms
MGX8850
MGX8850
NODE CONFIGURATION OPTIONS
Opt#
----
1
2
3
4
5
6
Enter option number (1-5): 1
NODE CONFIGURATION OPTIONS
Opt#
----
1
Interval used to measure maximum number of card resets allowed.
Enter 1800 at the prompt. The system subsequently displays the new setting.
Enter value for option 1: 1800
NODE CONFIGURATION OPTIONS
Opt#
----
1
You can enter the option number and option value without prompting, and the system shows the result.
MGX8850.7.PXM.a > cnfndparms 1 1800
NODE CONFIGURATION OPTIONS
Opt#
----
1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
State: active
Value Type
----- ----
3600 16bit Decimal
3 8bit Decimal
Yes Boolean
No Boolean
0x0 8bit Hex
0x0 8bit Hex
Value Type
----- ----
3600 16bit Decimal
Value must be greater than zero.
If nonzero, number of seconds used to measure card resets.
Value Type
----- ----
1800 16bit Decimal
Value Type
----- ----
1800 16bit Decimal
Privilege: SUPER_GP
System Rev: 02.01 Sep. 04, 2001 12:15:13 PST
Node Alarm: CRITICAL
Description
-----------
SHM Card Reset Sliding Window (secs)
SHM Max Card Resets Per Window (0 = infinite)
Core Redundancy Enabled
Expanded Memory on PXM45B Enabled
Required Power Supply Module Bitmap
Required Fan Tray Unit Bitmap
Description
-----------
SHM Card Reset Sliding Window (secs)
Description
-----------
SHM Card Reset Sliding Window (secs)
Description
-----------
SHM Card Reset Sliding Window (secs)
Cisco MGX 8850 Routing Switch Command Reference
cnfndparms
2-29