Dspconinfo - Cisco MGX 8850 Command Reference Manual

dspconinfo

dspconinfo
Display Summaries of Connection Information—display general information about SPVCs.
The dspconinfo runs on the PXM45 and lists the total number SPVCs on each PNNI port on the node.
the default is all ports on the node, but you can also specify a particular PNNI port. For each port, the
display shows:
•
•
•
•
•
•
Note that dspconinfo checks for the down state at the master end of the connection (status at the slave
endpoint is failed). See also the descriptions for dncon and dspcon.
Cards on Which This Command Runs
PXM45
Syntax
dspconinfo
[-port portid]
Syntax Description
-port
Related Commands
none
Attributes
Log: no log
Cisco MGX 8850 Routing Switch Command Reference
9-88
Number of active connections
Number of failed connections
Number of administratively inactive (or down) connections as a result of dncon
Number of alarm indication (AIS) failures
Number of A-bit failures
Total number of connections
Specifies a particular port for the connections. The default for this command is all
ports (portid not specified) You can specify a particular port by using the port
keyword followed by the portID in the following format:
[shelf.]slot[:subslot].port[:subport]
Currently, the value for shelf is 0 and so is not necessary.
State: active, standby
Chapter 9
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands