Dsppnports - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

dsppnports

Display Ports
The dsppnports command displays status for all logical ports. If you do not identify a particular type of
interface, the display shows all interface types.
In brief, the display consists of:
•
•
•
For details on the connection summaries, see the section,
Summaries."
Note The total number of connections that the display shows does not include control VCs. The types of
control VCs are SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts
that include control VCs, use the commands that operate on the CLI of the service modules (dspln,
dsppart or dsprscprtn, dspcd, and dspport).
Cards on Which This Command Runs
PXM45
Syntax
dsppnports [uni | nni | enni]
Syntax Description
uni
nni
enni
ILMI States
The display includes ILMI status, as follows:
Disable
NotApplicable
LostConnectivity Protocol on listening port is not enabled.
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
A summary of connections
The logical number associated with the PNNI port number (a format that some commands require)
A status summary for each port, including the number of connections on each port (excluding
control VCs)
Show status for only UNI ports.
Show status for only NNI ports.
Show status for only ENNI ports.
Protocol is not enabled on this port.
This port is not accessible due to hardware-related conditions.
"Description of the dsppnports Connection
Cisco MGX 8850 Routing Switch Command Reference
dsppnports
6-95