Dspports - Cisco MGX 8850 Command Reference Manual

dspports

dspports
Display Ports
Displays general information about all logical ports on the card. On the AXSM, the information consists
of the following for each logical port:
•
•
•
•
•
•
•
Cards on Which This Command Runs
AXSM
Syntax
dspports
Related Commands
addport, cnfport, delport, dspport
Attributes
Log: no log
Examples
Display the logical ports on the current AXSM. Note that if no SCT file had been specified for a
particular logical port (ifNum), the output gives a warning about the default SCT file usage for that port.
See also the description for the cnfcdsct command.
MGX8850.1.AXSM.a > dspports
ifNum Line Oper.
----- ---- ------ ---------- --------- ---------------------
Cisco MGX 8850 Routing Switch Command Reference
3-86
Logical port number (ifNum). On the AXSM, for example, the range is 1–60.
Physical line number in the format bay.port.
Operation status—whether the port is up or down.
The minimum guaranteed rate in cells per second.
The maximum allowed rate for the port in cells per second.
The ID of the port-level SCT (see addport).
The VPI number (applies only where virtual NNIs are available).
State: active, standby
Guaranteed Maximum
Status Rate
1 1.1 Up 10000
2 1.2 Down 10000
3 1.3 Down 10000
4 1.3 Down 10000
Privilege: ANYUSER
sctID
Rate
10000 4
10000 4
10000 4
10000 0 !DefaultSCT used!
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3 Equipment and Resource Provisioning
ifType VPI
(VNNI only)
------ ---------
UNI 0
UNI 0
VNNI 1
VNNI 2 UNI 0