Cisco MGX 8850 Command Reference Manual page 169

Chapter 3 Equipment and Resource Provisioning
cntrlrType
lslot
cntrlrName
Syntax Description for External Controller
Currently, the switch does not support an external controller.
Note
cntrlrId
x
cntrlrType
lslot
bay
line
vpi
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
A number in the range 1–3 that identifies a network controller. For internal
controllers, the numbers are reserved, as follows:
1 = PAR (Portable AutoRoute)—currently not used
2 = PNNI
3 = LSC (Label Switch Controller, also known as MPLS for Multiprotocol Label
Switch Controller)—currently not used
For an internal controller, the controller type (cntrlrType) must be the
Note
same as the controller ID (cntrlrId).
The logical slot number on which the controller resides. For the PXM45, lslot is 7
regardless of which card is active.
(Optional) A string to serve as a name for the controller.
A number in the range 4–20 that identifies a controller. (cntrlrId 1–3 is reserved for
PAR, PNNI, and MPLS/LSC, respectively.) For external controllers, cntrlrId can
differ from cntrlrType.
Keyword indicating that this controller is external.
A number in the range 1–3 that identifies the controller:
1 = PAR (Portable AutoRoute)—currently not used
2 = PNNI
3 = LSC (Label Switch Controller, also known as MPLS for Multiprotocol Label
Switch Controller)—currently not used
The number of the slot that has the virtual connection through which the controller
operates. The ranges are 1–6 and 9–16.
Applies to only external controllers. Upper or lower position of the back card. Type a
1 for upper bay or a 2 for lower bay.
Applies to only external controllers. A number specifying the physical line number.
The range is 1 through the highest number of lines on the back card. See
for a list.
Applies to only external controllers. VPI in the range 0–255.
Cisco MGX 8850 Routing Switch Command Reference
addcontroller
Table 3-1
3-9