Resetcd - Cisco MGX 8850 Command Reference Manual

resetcd

resetcd
Reset Card—resets the card or the failure history.
The resetcd command lets you reset a card or, if you specify the appropriate option, the failure history
of a card.
Using the resetcd command without defining a slot number results in an ungraceful (disruptive)
upgrade. This is the fastest method to upgrade a card, but it disrupts service.
A graceful (non-disruptive) upgrade requires that the loadrev, runrev, and commitrev commands have
already been executed and that the card is identified in the command string.
Cards on Which This Command Runs
PXM45
Syntax
resetcd
[slot]
[ -f]
Syntax Description
slot
-f
Related Commands
resetsys
Attributes
Log: no log
Example
Reset the current PXM45.
pinnacle.7.PXM.a > resetcd
The card in slot number 7, will be reset. Please confirm action
Do you want to proceed (Yes/No)? n
(command not executed)
Reset the failure history of the card in slot 1.
8850_NY.7.PXM.a > resetcd 1 -f
Clearing (-F) Failed state on slot 1. Please confirm action
resetcd: Do you want to proceed (Yes/No)?
Cisco MGX 8850 Routing Switch Command Reference
9-150
The optional slot parameter identifies a card to reset. If you do not specify a slot, the
command targets the current PXM45.
Specifies that the command resets only the failure history of a card.
State: active, init Privilege: SUPER_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 9 Troubleshooting Commands