Cisco MGX 8850 Command Reference Manual page 450

cnfpnctlvc
-scr
-mbs
Related Commands
dsppnctlvc (on the active control card), dspload (on a service module)
Attributes
Log: log
Example
Change the MBS of the PNN-RCC VC on port 3:1.1:1 to 100 cells. The system returns the error message
that the port is still in service. After downing the port with the dnpnport command, complete the task.
(If connections were on the port, they would go into alarm.) Check the control VCs with dsppnctlvc.
One section of the display (labeled "provisioned") shows configured parameters, and one section shows
operational VC parameters. In this example, the "provisioned" section reflects that you did not
configure bandwidth parameters other than MBS, and the "operational" section shows actual bandwidth
parameters—including the MBS you configured. Remember to re-activate the port by using uppnport.
8850_NY.8.PXM.a > cnfpnctlvc 3:1.1:1 sscop -mbs 100
ERROR: Port is not out-of-service
8850_NY.8.PXM.a > dnpnport 3:1.1:1
8850_NY.8.PXM.a > cnfpnctlvc 3:1.1:1 sscop -mbs 100
cnfpnctlvc Successful
8850_NY.7.PXM.a > dsppnctlvc 3:1.1:1
vc type = sscop
service category : sig
SCR :
vc type = sscop
service category : sig
SCR :
8850_NY.8.PXM.a > uppnport 3:1.1:1
Cisco MGX 8850 Routing Switch Command Reference
6-32
The sustained cell rate of the control VC.
Range: 1–5000 cps
Default:
If vc-type is pnnircc, the default is 453 cps.
•
• If vc-type is sscop, the default depends on the line rate.
The maximum burst size of the control VC.
Range: 1–1000 cells
Defaults:
If vc-type is pnnircc, the default is 171 cells.
•
• If vc-type is sscop, the default is 1000 cells.
State: active
Parameter = Provisioned
Not Provisioned
Parameter = Operational
2000
Chapter 6 Logical Node, Port, and Signaling Commands
Privilege: GROUP1
PCR : Not Provisioned
MBS : 100
PCR : 308000
MBS : 100
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001