Cisco MGX 8850 Command Reference Manual page 411

Chapter 5 PNNI Commands
dsppnni-svcc-rcc
Display PNNI Switched Virtual Connection Routing Control Channel (SVCC-RCC)
RCC table.
The dsppnni-svcc-rcc command displays the SVCC-RCC connection and packet values.
If you specify:
•
•
•
Cards on Which This Command Runs
PXM45
Syntax
dsppnni-svcc-rcc
[node-index [svc-index]]
Syntax Description
node-index
svc-index
Display Contents
The dsppnni-svcc-rcc command displays node, Hello packet, and SVC information for each RCC.
Related Commands
None
Attributes
Log: nolog
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Both node-index and svc-index, the display shows information about an SVCC-based RCC.
Only node-index, the display shows all SVC-based RCCs attached to the svc-index node.
Nothing, the display shows all SVC-based RCCs attached to all PNNI nodes in the network.
This system-generated indicates the relative position of a logical node within a
hierarchy. It has a range of 1–10. For a single-peer group, the only value for
node-index is 1.
Range: 1–10
Default: 1
PNNI uses the SVC index as a reference to the horizontal link (H-link) between the
levels in a multi-peer group. An SVC serves as the connection for an H-link.
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppnni-svcc-rcc
— display the PNNI SVC-based
5-117