Cnfalm - Cisco MGX 8850 Command Reference Manual

cnfalm

cnfalm
Configure Alarm
Configures statistical alarm thresholds for a line. The configurable items for SONET and PLCP are
defined in RFC 2258. The configurable items for DS3 and E3 are defined in RFC 2496. The items that
constitute a configuration are:
•
•
•
•
•
•
A keyword identifies the alarm criteria. Each keyword identifies the tested layer (line, and so on), the
type of threshold (errored seconds, and so on), and the test period of 15 minutes or 24 hours. For
example, -lnes15 indicates the number of errored seconds on the line layer during any 15 minute period.
See the Syntax Description for a list and definitions of all keywords.
Cards on Which This Command Runs
AXSM
Syntax
The required parameters are the line type the line identifier in the format bay.line, and the severity of
the alarm (minor or major). All other parameters are optional and must be preceded by the keyword that
identifies the type of parameter.
Generic Syntax Description
The generic syntax is.
cnfalm <line type> <bay.line> <alarm severity> <thresholds>
The meaning of the generic syntax appears in the following list. Refer to subsequent lists for the
descriptions of alarm severities and thresholds for each line type.
line type
bay.line
Cisco MGX 8850 Routing Switch Command Reference
9-26
Line type: SONET, DS3, E3, or PLCP
Tested layer: section, line, or path (for example, SONET line)
Test periods of 15 minutes and 24 hours
Degrees of error-time: errored seconds and severely errored seconds
Types of errors, including framing errors, code violations, and unavailable
Severity of alarm triggered when a threshold is crossed: minor or major
The line type is specified as one of the following keywords (including the hyphen):
-sonetsec (for SONET section)
-sonetline (for SONET line)
-sonetpath (for SONET path)
-ds3
-e3
-plcp
Identifies the bay (1 or 2) and the number of the line. The range for line can be 1 to
the highest numbered line on the back card.
Chapter 9 Troubleshooting Commands
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001