Delpnni-Node - Cisco MGX 8850 Command Reference Manual

Chapter 5 PNNI Commands

delpnni-node

Delete PNNI Node–delete a PNNI node from the PNNI network topology.
The delpnni-node command removes a PNNI node from the PNNI network topology. A node that this
command deletes can be restored with the related command addpnni-node. Confirm the deletion of
nodes with the dsppnni-node command.
Cards on Which This Command Runs
PXM45
Syntax
delpnni-node <node-index>
Syntax Description
node-index
Related Commands
addpnni-node, cnfpnni-node, delpnni-node
Attributes
Log: log
Example
Delete the node with the node-index of 3. Execute dsppnni-node and specify a node index of 3. The last
line of the d display shows the error "node does not exist," indicating you successfully deleted the node.
SanJose.7.PXM.a > delpnni-node 3
SanJose.7.PXM.a > dsppnni-node 3
Unknown Error Code
Syntax: dsppnni-node [node-index]
node does not exist
SanJose.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
In the current release, the only supported value for node-index 1. The node index
indicates the relative level of the logical node within a multi-peer group on the
switch. The range is 1–10, and the lowest level is 1.
Range: 1–10
Default: 1
State: active
nodeIndex -- node-index: 32 bit number starting from 1, Optional parameter
possible errors are:
Privilege: SUPER_GP
Cisco MGX 8850 Routing Switch Command Reference
delpnni-node
5-51