C H A P T E R 6 Logical Node, Port, And Signaling Commands; Position-Dependent And Keyword-Driven Parameters; Command Entry; Identifying The Axsm Models - Cisco MGX 8850 Command Reference Manual

Position-Dependent and Keyword-Driven Parameters

Position-Dependent and Keyword-Driven Parameters
A command can include parameters that are keyword-driven or position-dependent.
For position-dependent parameters, you must type parameters in the order they appear in the syntax
description or on-line help. To create a logical port, for example, the position-dependent syntax is:
addport <ifNum> <bay.line> <guaranteedRate> <maxrate> <sctID> <ifType> [vpi]
For a keyword-driven parameter, a keyword must precede the value. The keyword is preceded by a dash
and followed by the parameter (–timeout <secs>, for example). The order you enter keyword-driven
parameters does not matter—although any preceding or succeeding, position-dependent parameters
must appear as they do in the command syntax description.
In the following syntax example, the command is to delete more than one connection at a time. The
mandatory, position-dependent connection identifier consist of a logical port (ifNum) and the VPI and
VCI of the first connection to delete. After the connection identifier, the line shows two optional,
keyword-driven parameters. These keyword-driven parameters let you enter the number of connections
to delete and specify verbose mode:
delcons <ifNum> <vpi> <vci> [-num <num. conns to del>] [-verbose < 1 | 0 >]

Command Entry

When you enter a command with the current version of the product, you must type all intended
arguments before you press the Return key or Enter key.
If you press the Return key or Enter key with incorrect parameters or no parameters (if the command
requires parameters), a message displays the syntax and parameter ranges. The returned message may
also suggest what the problem is. For example, the message may warn of too few parameters. No error
messages or warnings appear until you complete the command.

Identifying the AXSM Models

The model number of an AXSM identifies the line speed, line count, and number of bays (see
Note that the number of lines applies to an individual back card, so the total number of lines supported
by the front card equals the highest line number times the number of bays. The OC-48 card
AXSM-1-2488 has the lowest number of lines—one. The highest number of lines exist on the
AXSM-16-155 and AXSM-16-T3E3—16, as the name indicates.
The MGX 8850node uses the concept of a bay. The bay refers to the upper or lower location of a
single-height card. (The switch has a double-height card cage, so a single-height back card necessarily
occupies either an upper or lower position.)
The T3/E3, OC-3, and OC-12 versions of the AXSM can have two back cards, one in bay 1 (upper
location of the back slot) and the second in bay 2 (lower slot). The MGX-AXSM-1-2488 (OC-48 AXSM)
can have a back card in bay 1 only. For further descriptions and illustrations of the card sets, refer to
Cisco MGX 8850 Hardware Installation, Release 2.
Cisco MGX 8850 Routing Switch Command Reference
6-2
Chapter 6 Logical Node, Port, and Signaling Commands
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Table 6-1.)