Dspapsbkplane - Cisco MGX 8850 Command Reference Manual

dspapsbkplane

dspapsbkplane
Display APS Backplane
Displays whether or not the APS mini-backplane is properly seated with the backcards.
When successful, this command displays:
BackPlane:ENGAGED
When not successful, this command displays:
BackPlane:NOT ENGAGED
See the addapsln command for an explanation of Automatic Protection Switching (APS).
See the Cisco MGX 8850 Routing Switch Hardware Installation Guide, Release 2, for information on
installing the APS assembly to the backplane.
Cards on Which This Command Runs
AXSM
Syntax
dspapsbkplane
Syntax Description
No parameters.
Related Commands
addapsln, cnfapsln, delapsln, dspapsln, dspapslns, switchapsln, clrbecnt, dspbecnt
Attributes
Log: no log
Example
Example of executing dspapsbkplane when an APS assembly is successfully installed to the backplane.
MGX 8850.6.AXSM.a > dspapsbkplane 6.1.3
BackPlane:ENGAGED
Example of executing dspapsbkplane when an APS assembly is not successfully installed to the
backplane.
MGX 8850.3.AXSM.a > dspapsbkplane 3.1.1
BackPlane:NOT ENGAGED
Cisco MGX 8850 Routing Switch Command Reference
3-48
State: active, standby
Chapter 3 Equipment and Resource Provisioning
Privilege: ANYUSER
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001