Dspalmcnf - Cisco MGX 8850 Command Reference Manual

Chapter 9 Troubleshooting Commands

dspalmcnf

Display Alarm Configuration
Display the threshold information about the alarm statistics being collected. Refer to the cnfalm
description for details regarding alarm threshold configuration.
Cards on Which This Command Runs
AXSM
Syntax
dspalmcnf
-sonetsec|-sonetline|-sonetpath|-ds3|-e3|-plcp <bay.line>
Syntax Description
-sonetsec
-sonetline
-sonetpath
-ds3-
-e3
-plcp
bay.line
Related Commands
cnfalm, dspalm, dspalms
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Keywords that specify the type of alarms to display:
-sonetsec – Displays the section alarms for the given sonet line (bay.line).
•
sonetline – Displays the line alarms for the given sonet line (bay.line).
•
-sonetpath –Displays the path alarms for the given sonet line (bay.line).
•
• -ds3 – Displays the statistical alarms for the given DS3 line (bay.line).
-e3 – Displays the statistical alarms for the given E3 line (bay.line).
•
• -plcp – Displays the PLCP alarms for the given line (bay.line). Physical Layer
Convergence Procedure (PLCP) is the specification that maps ATM cells into
physical media, such as T3 or E3, and defines certain management information.
Specifies the type of line, the bay (1 or 2), and the number of the line. The line number
can be 1 to the highest numbered line on the back card.
State: active, standby, Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dspalmcnf
9-53