cnfilmienable
cnfilmienable
Enables ILMI on a PNNI port. Prior to cnfilmienable, you must use dnpnport to de-activate the port.
Cards on Which This Command Runs
PXM45
Syntax
cnfilmienable <portid> [yes | no]
Syntax Description
portid
Related Commands
uppnport, dsppnport, dsppnilmi
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
4-10
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport]. See
also
PNNI Format, page
4-2.
State: active
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 4
ILMI Commands