Cnftmzngmt - Cisco MGX 8850 Command Reference Manual

cnftmzngmt

cnftmzngmt
Configure Time Zone Relative to GMT
Configures the time zone for the node relative to GMT. Typically, this command applies to nodes outside
the four standard time zones of the Western Hemisphere. Use cnftmzngmt according to the following
sequence:
•
•
Use dspdate to see the time.
Cards on Which This Command Runs
PXM45
Syntax
cnftmzngmt <timeoffsetGMT>
Syntax Description
timeoffsetGMT
Related Commands
cnftmzn, cnftime, cnfdate, dspdate
Attributes
Log: log
Example
Set time zone in the shelf to GMT plus 4 hours.
excel.1.3.PXM.a > cnftmzngmt 4
Cisco MGX 8850 Routing Switch Command Reference
2-36
First use cnftmzn to specify the time zone as GMT.
Then specify an offset in hours relative to Greenwich Mean Time by executing cnftmzngmt. The
values are GMT plus or minus an integer in the range 1–12.
Number of hours offset from GMT in the range -12 through 12.
State: active
Chapter 2
Privilege: SUPER_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Shelf Management Commands