Cisco MGX 8850 Command Reference Manual page 188

cnfcdsct
Syntax
cnfcdsct <SCT-id>
Syntax Description
SCT-id
Related Commands
dspcdsct, dspcd, dspsct
Attributes
Log: log
Example
Specify card-level SCT number 3 for the current AXSM.
MGX8850.9.AXSM.a > cnfcdsct 3
The SCT file must reside on the PXM disk before you use this command, or it fails and displays the error
message in the following example:
MGX8850.1.6.AXSM.a > cnfcdsct -sct 5
ERR:SCT file not present. Use tftp to load it on PXM disk
Set failed due to illegal option value(s)
Syntax: cnfcdsct "<sctID>"
Cisco MGX 8850 Routing Switch Command Reference
3-28
Number of the SCT at the card-level. The range is 1–255.
State: active
sctID -- SCT file id between 0 and 255
Chapter 3 Equipment and Resource Provisioning
Privilege: GROUP1
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001