Cnfatmln - Cisco MGX 8850 Command Reference Manual

Chapter 3 Equipment and Resource Provisioning

cnfatmln

Configure ATM Line
Configures the ATM layer cell header for the specified line (bay.line).
You must configure the ATM layer cell header for a line before you activate the line using upln, or
before you add a logical port to the line using addport.
Cards on Which This Command Runs
AXSM
Syntax
cnfatmln
-ln <bay.line>
-sps <PayloadScramble>
-nch <cellhdr>
-ncp <cellpayload>
-hcs <hcs>
Syntax Description
-ln
-sps
-nch
-ncp
-hcs
Related Commands
dspatmln
Attributes
Log: log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specifies the bay and line number in the format bay.line. The bay is 1 or 2. The line
can be from 1 to the highest numbered line on the back card. For the line number
ranges on an AXSM model, see
Specifies the number that enables (1) or disables (2) payload scrambling. The default
value for PayloadScramble is enabled. The setting must be the same at both ends of
the line and throughout the path.
Specifies the four-byte hexadecimal number to serve as the null cell header (cellhdr).
The range for cellhdr is all 0s through ffffffff.
Specifies a 8-bit hexadecimal byte to serve as the null cell header. The range for
cellpayload is 1–ff. The default is 6a.
Specifies the number to disable (1) or enable (2) HCS coset The default is enabled.
State: active
Table 3-1.
Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnfatmln
3-25