Disablesscop - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

disablesscop

Disable SSCOP
The disablesscop command lets you disable SSCOP on a port. The port must be administratively down
(by the dnpnport command). Be sure a valid and useful reason exists for disabling SSCOP.
Cards on Which This Command Runs
PXM45
Syntax
disablesscop <portid> {yes | no}
Syntax Description
portid
yes or
no
Related Commands
cnfsscop, dspsscop, dspsscopstats
Attributes
Log: nolog State: active
Example
Disable SSCOP on port 11:2.8:28.
Geneva.7.PXM.a > disablesscop 11:2.8:28 yes
Geneva.7.PXM.a >
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport]. See
also PNNI Format, page 6-4.
The choice for disabling or enabling SSCOP on the port:
• yes means disable SSCOP.
no means enable SSCOP.
•
Default: no (enable SSCOP on the specified port)
Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
disablesscop
6-63