Dspsigparm - Cisco MGX 8850 Command Reference Manual

dspsigparm

dspsigparm
Display Signaling Parameter
The dspsigparm command shows whether the switch is enabled to perform frame discard on AAL5
cells. The cnffdonaal5 command lets you enable or disable frame discard for AAL5 cells. The default
is enabled.
Cards on Which This Command Runs
PXM45
Syntax
dspsigparm
Syntax Description
This command takes no parameters.
Related Commands
cnffdonaal5
Attributes
Log: nolog
Example
Determine whether frame discard for AAL5 cells is enabled on this switch.
SanJose.7.PXM.a > dspsigparm
Global Signaling Parameters
============================
Frame Discard on AAL5 IE: yes
SanJose.7.PXM.a >
Cisco MGX 8850 Routing Switch Command Reference
6-106
State: active, standby Privilege: ANYUSER
Chapter 6 Logical Node, Port, and Signaling Commands
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001