Dspln - Cisco MGX 8850 Command Reference Manual

Chapter 3 Equipment and Resource Provisioning

dspln

Display Line
Display the characteristics of a physical line.
Note The connection count includes control VCs when you use dspln on a service module. However, when
you use dspcd or dsppnport(s) on the CLI of the PXM, the display does not include control VCs.
Cards on Which This Command Runs
AXSM
AXSM Syntax
dspln <-ds3 | -sonet> <bay.line>
AXSM Syntax Description
-ds3
-sonet
bay.line
Related Commands
upln, cnfln
Attributes
Log: no log
Examples
Display T3 line 1 on the current AXSM.
MGX8850.11.AXSM.a > dspln -ds3 1.1
Line Number
Admin Status
Line Type
Line Coding
Line Length(meters) : 0
OOFCriteria
AIS c-Bits Check
Loopback
Xmt. Clock source
Rcv FEAC Validation : 4 out of 5 FEAC codes
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Command delineator that precedes the bay.line number entry for a T3 line.
Command delineator that precedes the bay.line number entry for a SONET line.
Identifies the bay (1 or 2) and the number of the line. The line number is from 1 to the
highest numbered line on the back card. For the range of line numbers on specific
AXSM models, see Table
State: active, standby
: 1.1
: Down
: ds3cbitadm
: ds3B3ZS
: 3Of8Bits
: Check
: NoLoop
: localTiming
3-1.
Privilege: ANYUSER
Alarm Status
Number of ports
Number of partitions: 0
Number of SPVC
Number of SPVP
Number of SVC
Cisco MGX 8850 Routing Switch Command Reference
dspln
: Clear
: 0
: 0
: 0
: 0
3-75