Cnfautocnf - Cisco MGX 8850 Command Reference Manual

Chapter 4 ILMI Commands

cnfautocnf

Configure Auto Configuration
The cnfautocnf command enables or disables ILMI auto configuration for a port. To use this command,
the port must be added but administratively down (via dnpnnport).
With auto-configuration enabled, the ILMI slave side starts ILMI auto configuration to negotiate the
ATM layer parameters with its peer while ports come up. With auto-configuration disabled, the ILMI
slave does not start ATM layer parameter-negotiation while ports come up. Instead, the ILMI slave uses
the local configuration parameters. The default state for auto-configuration is enabled.
Cards on Which This Command Runs
PXM45
Syntax
cnfautocnf <portid> [yes | no ]
Syntax Description
portid
yes
no
Attributes
Log: log
Examples
Enable ILMI auto-configuration on port 4:1.1:11.
Geneva.1.AXSM.a > cnfautocnf 4:1.1:1 no
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page
Enable ILMI automatic configuration on the port.
Default: yes
Disable ILMI automatic configuration on the port.
State: active
4-2.
Privilege: GROUP1
Cisco MGX 8850 Routing Switch Command Reference
cnfautocnf
4-7