Dspconsegep - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

dspconsegep

Display Connection Segment Endpoint
Displays oam segment endpoint for a connection endpoint. When both vpi and vci are present, the
segment endpoint is a F5 flow endpoint (for VCCs). When the optional vci is not present, the segment
endpoint is a F4 flow endpoint (for VPCs). This command applies to established calls only.
Cards on Which This Command Runs
PXM45
Syntax
dspconsegep <portid> vpi [vci]
Syntax Description
portid
vpi
vci
Related Commands
cnfoamsegep, dspoamsegep, cnfconsegep, delconsegep
Attributes
Log: log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page
The VPI of the connection.
The VCI of the connection.
State: active, standby
6-4.
Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dspconsegep
6-67