Cisco MGX 8850 Command Reference Manual page 150

setrev
Using the example of axsm_002.000.000.001.fw, the version is 2.0(1.1). Similarly, if no patch were
present, the version number would be 2.0(1).
Pre-release, developmental versions have one or two alphanumeric characters at the end of the version
number, and these versions may appear in various contexts. For example, the help display for setrev
gives examples of revision, but only the first two in the following list could be in released product. These
two bullets show major release 2, minor release 1, and the minimal maintenance number of 1. The last
three bullets show developmental revision numbers:
•
•
•
•
•
The setrev command resets the active PXM45 only if the revision changes on the active card are a
Note
result of the setrev command.
Cards on Which This Command Runs
PXM45
Syntax
setrev <slot> <version>
With the current release, the primary and secondary images are the same. For this reason, you do not
Note
specify the secondary revision, so the syntax line indicates only "version."
Syntax Description
slot
version
Related Commands
loadrev, runrev, commitrev, abortrev, dspversion, dspcd
Attributes
Log: log
Cisco MGX 8850 Routing Switch Command Reference
2-92
2.0(1) Note the absence of a patch number.
2.0(1.248) Note the patch number is 248.
2.0(0.1)A1 Note the phase number is A1.
2.0(0.10)D2 Note the phase number is D2.
2.0(0.248)P1, 2.0(0.1)P2, 2.0(0.113)P3, 2.0(0.10)P4
Slot number of the card targeted for firmware specification.
An alphanumeric string derived from the name of the firmware file. For an explanation
of the numbering scheme, see the section,
the setrev description.
State: active
Chapter 2
"Version Numbering
Privilege: SERICE_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Shelf Management Commands
Conventions," earlier in