Cnfmbsdft - Cisco MGX 8850 Command Reference Manual

Chapter 7 SPVC and SVC Commands

cnfmbsdft

Configure Maximum Burst Size Default
Configures the default maximum burst size (MBS) for SPVCs on a port. The applicable service types
are real-time and non real-time variable bit rate (rt-VBR and nrt-VBR).
The most likely connection type for which you would use cnfmbsdft is SVC. You can also rely on the
value set with this command as a default for SPVCs if you do not specify an MBS through addcon for
each SPVC of service type VBR.
The new configuration applies to new incoming calls, not existing calls. You can use cnfmbsdft whether
the port is active or in the provisioning state.
Cards on Which This Command Runs
PXM45
Syntax
cnfmbsdft <portid> <service_category>
[num-of-cell]:
Syntax Description
portid
service_category
num-of-cell
Related Commands
dspmbsdft
Attributes
Log: log
Examples
Configure a default MBS of 10000 cells for nrt-VBR.
cnfmbsdft 11:2.1:1 nrtvbr 10000
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The portid represents the PNNI physical port and has the format
[shelf.]slot[:subslot].port[:subport]. See also
ATM 4.0 service category—either rtvbr or nrtvbr.
The units of measure for MBS are cells.
Range: 0–2147483647 cells
Default: set by the platform to 1024 cells.
State: active Privilege: GROUP1
PNNI Format, page
Cisco MGX 8850 Routing Switch Command Reference
cnfmbsdft
7-4.
7-29