Addpnni-Summary-Addr - Cisco MGX 8850 Command Reference Manual

addpnni-summary-addr

addpnni-summary-addr
Add PNNI Summary Address
The addpnni-summary-addr command lets you create a summary address for a logical node. The result
of this operation is a range of addresses. The controller uses this summary to accept or reject calls that
arrive at an address within the address range. Using a summary address decreases both the provisioning
time and the call setup time for an address within the range.
Cards on Which This Command Runs
PXM45
Syntax
addpnni-summary-addr <node-index> <address-prefix> <prefix-length>
[-type {internal | exterior}]
[-suppress {true | false}]
Syntax Description
The defaults for address prefixes and the peer group ID share values with the ATM address. If you
change the peer group ID (-pgId) you should change the corresponding fields in the PNNI summary
address. (See
Figure 5-5
hierarchy
Cisco MGX 8850 Routing Switch Command Reference
5-12
— create a PNNI summary address to specify a range of addresses.
Figure 5-5.)
Cisco Factory-shipped Defaults for PNNI Peer Group Identifier, PNNI Summary Address,
ATM Address, and PNNI Node Identifier
ATM
address
ATM
format
address
Cisco
length
ICD
PNNI
56 160 47 00 91 81 00 00 00 XX XX XX XX XX XX XX XX XX XX XX XX 00
level
# of 1 1 1 2
Bytes
Default PNNI
peer group identifier
MAC address
1 3 6
Default PNNI
summary address
Default ATM address
Default PNNI
node identifier
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 5 PNNI Commands
MAC address
6 1