Cisco MGX 8850 Command Reference Manual page 132

ipifconfig
pvc | nopvc
default |
nodefault
clrstats
Related Commands
dspipif, pvcifconfig, dsppvcif, svcifconfig, dspsvcif, dspipifcache
Attributes
Log: no log
Example
Specify a IP interface with an ATM interface type, address of 163.72.29.177, and a net mask of
255.255.255.000, and use the defaults for all other parameters.
wilco.7.PXM.a > ipifconfig atm0 163.72.29.177 mask 255.255.255.000
Cisco MGX 8850 Routing Switch Command Reference
2-74
(Optional) Specify whether PVC support is enabled. The default for this parameter is
enabled (pvc). The application of PVC support is for a device in the network
management path that provides IP connectivity but does not support SVCs. With PVC
support enabled, you subsequently set up a PVC to that device by executing
pvcifconfig. If PVC support is not enabled, pvcifconfig fails.
If you change this value, type the word pvc or nopvc in its entirety.
(Optional) Specifies whether to use this interface as the default interface. As stated in
the description of the interface parameter, the default interface is Ethernet the first
time the switch powers up. You can change the default by entering the default or
nodefault keyword. For example, if you currently are specifying an ATM interface
(atm0) on the control port, you can make it the default (upon subsequent node reset)
by typing the keyword default.
Clear all interface and connection statistics for the specified interface type. The
statistics pertain to incoming and outgoing packets, errored packets, and so on.
State: active
Chapter 2
Privilege: SUPER_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Shelf Management Commands