Dsppncons - Cisco MGX 8850 Command Reference Manual

Chapter 6 Logical Node, Port, and Signaling Commands

dsppncons

Display Port Connections
Displays a summary of SVCs and SPVCs on one port or all ports. The default is all connections on all
ports because all parameters are optional. You can specify a starting VPI or VCI to begin a range of
connections. In addition, you can display one of two types: point-to-point or point-to-multipoint.
Cards on Which This Command Runs
PXM45
Syntax
dsppncons
[-port portid]
[-vpi starting-vpi]
[-vci starting-vci]
[-type {p2p | p2mp}]
Syntax Description
-port
-vpi
-vci
-type
Related Commands
dsppncon
Attributes
Log: nolog
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
The portid is the PNNI physical port. The format is [shelf.]slot[:subslot].port[:subport].
See also PNNI Format, page
Starting VPI.
Starting VCI.
Causes the system to display only point-to-point or point-to-multipoint. Without this
option, the system displays both types. No default value exists if you include the keyword
type on the command line, you must enter one of the possible entries.
"p2p" for point-to-point
•
"p2mp" for point-to-multipoint
•
State: active, standby
6-4.
Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dsppncons
6-81