Clrxbaralm - Cisco MGX 8850 Command Reference Manual

clrxbaralm

clrxbaralm
Clear Crossbar Alarm—clear the crossbar alarms.
To see the alarms that clrxbaralm clears, execute dspxbaralarm or dspswalms. The clrxbaralm
command clears the alarms for either a specific switch plane or for all the switch planes on the active
switching card. In an MGX 8850 node, the switching slot is the slot number of the PXM45.
Cards on Which This Command Runs
PXM45
Syntax
clrxbaralm < * | [ slot plane ]>
Syntax Description
*
slot
plane
Related Commands
dspxbaralm, dspswalms
Attributes
Log: log
Example
Clear the alarms for switch plane 0 in slot 7. The system returns no messages unless an error exists in
the command syntax. To see the results, execute dspxbaralm.
pop20two.7.PXM.a > clrxbaralm 7 0
Cisco MGX 8850 Routing Switch Command Reference
9-24
Enter an asterisk to clear all crossbar alarms on the active PXM45.
The slot number of the crossbar planes. The slot number is 7 or 8.
The range for plane numbers is 0–2.
State: active
Chapter 9
Privilege: SUPER_GP
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Troubleshooting Commands