Cisco MGX 8850 Command Reference Manual page 561

Chapter 7 SPVC and SVC Commands
Local-Only Parameters
The parameters CDVT, stats enable, cc enable (specified using -cdvt, -stat, -cc) are significant only at
the endpoint where you enter them. Therefore, they can be different at each end of the connection.
AXSM Syntax
cnfcon
<ifNum>
<vpi>
<vci>
[-lpcr <local to remote PCR>]
[-rpcr <remote to local PCR>]
[-lscr <local to remote SCR>]
[-rscr <remote to local SCR>]
[-lmbs <local to remote MBS>]
[-rmbs <remote to local MBS>]
[-lcdv <local to remote maxCDV>]
[-rcdv <remote to local maxCDV>]
[-lctd <local to remote maxCTD>]
[-rctd <remote to local maxCTD>]
[-lmcr <local to remote MCR>]
[-rmcr <remote to local MCR>]
[-cdvt <local CDVT>]
[-cc <OAM CC Cnfg>]
[-stat <Stats Cnfg>]
[-frame <frame discard>]
[-mc <Max Cost>]
[-segep <OAM segment endpoint>]
AXSM Syntax Description
ifNum
vpi
vci
- lpcr
- rpcr
- lscr
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Logical port number. On the AXSM, the range is 1–60.
Virtual path identifier in the range 0–255 (UNI) or 0–4095 (NNI or VNNI).
Virtual connection identifier (VCI):
• For a VCC on a UNI, the range is 1–4095. On an NNI or VNNI, the VCI range is
32–65535. For MPLS, the recommended minimum VCI is 35.
• For a VPC, the vci is 0.
Keyword that specifies the Peak Cell Rate (PCR) from a local endpoint to a remote
endpoint (7–5651328 cells per second). Peak Cell Rate is the maximum cell rate for
the connection at any time.
Keyword that specifies the Peak Cell Rate (PCR) from a remote endpoint to a local
endpoint (7–5651328 cells per second). Peak Cell Rate is the maximum cell rate for
the connection at any time.
Keyword that specifies the Sustained Cell Rate (SCR) from a local endpoint to a
remote endpoint (7–5651328 cells per second). Sustained Cell Rate is the maximum
cell rate that a connection can sustain for long periods.
Cisco MGX 8850 Routing Switch Command Reference
cnfcon
7-25